Filter
Top Products
G-5
Power Cord The cord used to connect the copier to the power receptacle. The plug
design is specified depending on the amount of power the copier requires.
Make sure the receptacle is the correct one for your copier.
READY Indicator This is an indicator that shows when the copier has warmed up and is
ready to make copies. It appears in several forms; a light, an icon, and the
message itself.
Release Lever The lever located inside the Front Cover used to release the Upper Unit
for access to the paper path.
Separation Corona One of the Coronas inside the copier. It is usually located near the Drum
and separates the paper from the Drum. Because it attracts the toner, and
since it is located below the paper, it has a tendency to get dirty. This can
require the Key Operator to either clean the coronas or call for service.
Sheet Feed Bypass A tray that opens from the side of the machine, usually just above the
Primary Paper Tray or LCC. It is designed to feed a single sheet at a time.
This tray can be used to feed paper or transparency stock that would
normally not be placed in the Feed Drawers. Since it bypasses the normal
paper feeding mechanism and feeds straight through the paper path,
heavier stocks (like cover stock) feed better.
Sorter An accessory attached to the output of a copier designed to perform a
sorting function. The sort function allows you to make multiple copy sets
of an original in such a way that the pagination matches the original
document.
Stack Feed Bypass
Feed Tray
A tray that opens from the side of the machine, usually just above the
LCC or Primary Paper Tray, and is designed to feed a stack of paper. This
tray can be used to feed paper or transparency stock that would normally
not be placed in the Feed Drawers. Since it bypasses the normal paper
feeding mechanism and feeds straight through the paper path, heavier
stocks (like cover stock) feed better.
Stack Key This key is used to program the Stack functions. This is available only if a
Sorter or Finisher is present. In the stack mode, multiples of a single page
of a document are placed in separate Sorter Trays or are offset in the
Finisher Tray.
Start Key This Key is used to start the copying process once all selections have been
made. On a Lanier copier, it is always green in color.
Toner The black powder that is used to form the image on copy paper. In a color
copier, it would be colored. PLEASE NOTE: Toners are designed to
operate specifically in a copier and differ greatly on the copier
requirements. Toner from other copiers should never be mixed. At best,
the image would be too light or too dark. At worst, it can damage your
copier and require a service call to have the toner cleaned out and
replaced with the correct toner.