Filter
Top Products
Remarks
144
7
❒ Do not carry the machine, by hold-
ing the scanner assembly. Keep the
machine level and carry it careful-
ly, taking care not to jolt or tip it.
Rough handling may cause a mal-
function or damage the hard disk
or memory, resulting in loss of
stored files.
❒ Do not take off the holding stand.
❒ Protect the machine from strong
shocks. Impact can damage the
hard disk and cause stored files to
be lost. As a precautionary meas-
ure, files should be copied to an-
other computer.
Power Connection
R
WARNING:
R
CAUTION:
R
CAUTION:
• When the main power switch is in
the stand-by position, the optional
anti-condensation heaters are on.
In an emergency, unplug the ma-
chine's power cord.
• When you unplug the power cord,
the anti-condensation heaters turn
off.
• Make sure the plug is inserted
firmly in the wall outlet.
• Voltage must not fluctuate by
more than 10%.
• The wall outlet shall be installed
near the machine and shall be eas-
ily accessible.
Access to the Machine
Place the machine near the power
source, providing the clearance areas
shown.
1. Rear: more than 1 cm (4")
2. Right: more than 1 cm (4")
3. Front: more than 75 cm (29.6")
4. Left: more than 1 cm (4")
Note
❒ For the required space when op-
tions are installed, contact your
service representative.
• Connect the machine only to
the power source described on
the inside front cover of this
manual. Connect the power
cord directly into a wall outlet
and do not use an extension
cord.
• Do not damage, break or make
any modifications to the power
cord. Do not place heavy ob-
jects on it. Do not pull it hard
nor bend it more than neces-
sary. These actions could
cause an electric shock or fire.
• Unplug the power cord from the
wall outlet before you move the
machine. While moving the ma-
chine, you should take care that
the power cord will not be dam-
aged under the machine.
• When you disconnect the power
plug from the wall outlet, always
pull the plug (not the cable).
CP999EE