Filter
Top Products
7: Advanced Settings and Defaults (Setup Mode)
WiBox2100E User Guide 30
HTTP Port Number
This option enables configuration of the web server port number. The valid range is
1-65535. The default HTTP server port number is 80.
HTTP Port Number : (80) ? _
MTU Size
The Maximum Transmission Unit (MTU) is the largest physical packet size a network can
transmit for TCP and UDP. Enter between 512 and 1400 bytes. The default is 1400
bytes.
MTU Size: (1400) ? _
Enable alternate MAC
If necessary, enable the alternate MAC address (if specified in the OEM setup record).
Enable alternate MAC (N) ? _
Ethernet Connection Type
The WiSpan allows you to configure the Ethernet speed and duplex manually.
Enter 0 for auto-negotiation (default). To select the speed and duplex, enter one of the
following: 2 (10 Mbit/half duplex), 3 (10 Mbit/full duplex), 4 (100 Mbit/half duplex), or
5 (100 Mbit/full duplex).
Ethernet connection type: (0) ? _
Configurable Server Port Number
The device attached to the WiSpan may communicate with other CoBos devices on the
wireless network using the Lantronix Configuration Access Protocol (LCAP). This service
is available on server port number 0x77FE (30718) and is configurable so that the LCAP
service is available on the wired interface for WiSpan configuration.
Config Server Port Number: (30718) ? _
Security Settings
Note: Current values display in parentheses.
You can only use a Telnet or serial connection to change Security settings.
Note: Lantronix recommends setting security over the dedicated network or over
the serial setup. Parameters set over the network (Telnet 9999), may allow
someone else to capture these settings.
Caution: Disabling both Telnet setup and Port 77FE prevents users from
accessing the setup menu from the network.
Disable SNMP
If required for security purposes, disable SNMP on the WiSpan unit.