Lantronix XPort Network Card User Manual


 
XPort™ User Guide 7
1: Using This Guide
Purpose and Audience
This guide provides the information needed to configure, use and update the XPort™
and is intended for software developers and system integrators who are embedding
the XPort in their designs. The information in this guide is relevant to XPort with
firmware version 1.5 and higher.
Note: This document covers XPort™ Device Server versions XP1001000-01,
XP1001000-03, and XP1004000-03 (XPort-485).
Chapter Summary
The remaining chapters in this guide include:
2:Introduction
Describes the main features of the XPort and the
protocols it supports.
3:Getting Started
Provides information for getting your unit up and running,
using DeviceInstaller to assign an IP address, and Web-
Manager to set parameters such as port and server
properties.
4:Using Setup Mode
Provides instructions for accessing Setup Mode
(command line interface) using a Telnet connection
through the network or a terminal or terminal emulation
program through the serial port. Details the parameters
that you must configure.
5:GPIO Interface
Provides instructions for configuring the three General
Purpose I/O pins (CP1-3).
6:Updating Firmware
Provides instructions for obtaining the latest firmware and
updating the XPort.
7:Monitoring the Network
Provides instructions for accessing and using the
command line interface for monitoring the network and
diagnosing problems.
8:Troubleshooting
Describes common problems and error messages and
how to contact Lantronix Technical Support.