Lathem 800P Time Clock User Manual


 
800P TruAlign Time Recorder User Guide
Page 8
Quick Easy Setup (Wall Mount)
To setup your 800P, follow these next steps:
Step 1
Separate the back-plate from the
800P by removing the Philips
head screw. Retain the screw for
later.
Step 5
Align and place the 800P on the
back-plate and secure the two
together with the 8-32 x ¼ Philip
head screw. Be careful not to pinch
the AC cord.
Factory Settings
Time=U.S. Eastern Time
Daylight Savings=On
Spring Daylight Savings=Second
Sunday in March
Fall Daylight Savings=First
Sunday in November
Displayed Time Format=AM/PM
hours & Minutes
Printed Time Format=AM/PM
hours & Minutes
Day of Week Language=English
Confirmation Beep=Disabled
Step
3
Using the supplied 8-32 x ¼
Philips head screws install the
back-plate to the wall-mount
bracket.
Step 2
Install the wall-mount bracket
to the wall using the supplied
wall-mount screws. Note: For
best visibility mount the 800P
about 48 inches from the floor.
48
inches
Step
4
With the back-plate secured to
the wall-mount bracket, plug
the AC wall adapter into the
800P.
Note: The time, date and other
settings are factory set. See
“Factory Settings” below. If
these settings are acceptable
you are ready to begin,
otherwise see Page 11
“Programming the 800P”.
Note:
Make sure
the bottom of
the timecard
shelf is over the
edge of the
back-plate
before securing
the screw.