Filter
Top Products
Note: When the power cord is rst plugged in, the computer might appear to turn on for a few seconds and
then turn off. This is a normal sequence for the computer to initialize.
Installing a computer cover
To install a computer cover, do the following:
1. Replace the two rubber tabs you had previously removed.
2. Replace the cover so that the slots on the top edge of the computer cover align with the tabs on the
computer.
3. Lower and press one end of the computer cover into place rst and then close the other end until
the computer cover ts snugly on the computer.
4. Use the screwdriver to tighten the two screws 1 until the computer cover is fully installed on the
computer.
Installing a computer stand
To install a computer stand, do the following:
1. Turn off the computer.
2. Disconnect all cables, power cords, and external options from your computer. See “Locating connectors
on the rear of your computer” on page 68.
3. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the bottom is facing you.
4. Position the computer stand over the back of the computer and insert the two tabs at the front of the
computer stand into the two holes in the cover at an angle.
110 ThinkCentre Hardware Maintenance Manual