Filter
Top Products
pinched between the hard disk drive fan assembly and the hard disk drive
backplane when the assembly is installed.
c. Rotate the hard disk drive fan assembly toward the backplane until the
release tabs are fully engaged and snaps in place.
11. Reconnect the hard disk drive fan assembly cable to the system board.
12. Rotate the drive cage back into the server until it stops; then, press and hold
the retaining tab on top of the drive cage while you rotate the drive cage into
the chassis until it locks into place.
13. Reinstall the hard disk drives.
Note: Before you continue, check all internal power cables to make sure that
they are connected to the system board and other optional devices.
14. Install the side cover (see “Installing the side cover” on page 63).
15. Lock the side cover.
16. Reconnect the external cables and power cords; then, turn on the attached
devices and turn on the server.
Removing an IBM Remote Supervisor Adapter II SlimLine adapter
To remove a Remote Supervisor Adapter II SlimLine adapter from the server,
complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 57.
2. Turn off the server and all attached devices; then, disconnect all power cords
and external cables.
3. Unlock and remove the side cover (see “Removing the side cover” on page 62).
4. Rotate the rear adapter-retention bracket out of the server.
5. Press the Remote Supervisor Adapter II SlimLine support-bracket-retention clip
outward slightly and grasp the Remote Supervisor Adapter II SlimLine adapter
and lift it out of the server.
112 ThinkServer TS100 Types 6431, 6432, 6433, and 6434: Hardware Maintenance Manual