Filter
Top Products
Table 1. Features and specifications
Microprocessor:
One Intel
®
LGA 775 single core, dual
core, or quad core, depending on the
server model:
v Single core: Celeron 440 or later
v Dual core: Core 2 Duo E4600 or
Xeon E3110, or later
v Quad core: Xeon 3300 series
Notes:
1. Use the Configuration/Setup Utility
program to determine the size of
the L2 cache, type and speed of
the microprocessor, and speed of
the front-side bus.
2. Intel Virtualization Technology (VT)
is not available on the Celeron
440 or the Core 2 Duo E4600;
however, these microprocessors
can run paravirtualization.
Memory:
v Minimum: Two 512 MB DIMMs
v Maximum: 8 GB
v Type: PC2-5300, 667 MHz, ECC,
DDR II unbuffered SDRAM DIMMs
v Slots: Four dual inline
v Supports 512 MB, 1 GB, and 2 GB
DIMMs
Drives:
Ultrabay
Enhanced: CD or CD/DVD
Expansion bays:
One
of the following configurations:
v Two 3.5-inch slim-high bays for
hard disk drives.
– Hot-swap models: Supports
maximum of two serial-attached
SCSI (SAS) drives or two serial
ATA (SATA) drives.
– Simple-swap models: Supports
maximum of two SATA drives
v
Four 2.5-inch small form-factor
(SFF) hot-swap bays for hard disk
drives. Supports a maximum of four
2.5-inch SAS drives.
Expansion slots:
Two PCI Express x8 slots, one
low-profile and one 3/4-length full
height. Low-profile slot supports x4
electrical.
Video controller:
v ATI ES1000 video on system
board
v 16 MB DDR II video memory
Power
supply:
351
watt (110 or 220 V ac
auto-sensing)
Size:
v Height: 43 mm (1.75 inches, 1 U)
v Depth: 559 mm (22 inches)
v Width: 440 mm (17.32 inches)
v Maximum weight: 12.7 kg (28 lb)
depending on your configuration
Integrated
functions:
v Two Broadcom NetXtreme
™
GB
Ethernet controllers on the system
board
v Serial port
v Four USB ports (two on front and
two on rear of server)
v Systems-management port if an
optional Remote Supervisor
Adapter II SlimLine is installed
Hard
disk controllers:
v Serial ATA (SATA) controller
(simple-swap SATA models)
v Serial-attached SCSI (SAS)
controller with integrated RAID
(hot-swap SAS/SATA models) that
supports RAID levels 0, 1, 1E
Environment:
v Air temperature:
– Server on: 10° to 35°C (50.0°
to 95.0°F); altitude: 0 to 914.4
m (3000 ft)
– Server on: 10° to 32°C (50.0°
to 89.6°F); altitude: 914.4 m
(3000 ft) to 2133.6 m (7000 ft)
– Server off: 10° to 43°C (50.0°
to 109.4°F); maximum altitude:
2133.6 m (7000 ft)
– Shipping: -40° to 60°C
(-40° to 140°F); maximum
altitude: 2133.6 m (7000 ft)
v
Humidity:
– Server on: 8% to 80%
– Server off: 8% to 80%
Acoustical noise emissions:
v Sound power, idling: 6.5 bel
maximum
v Sound power, operating: 6.5 bel
maximum
Heat
output:
Approximate
heat output in British
thermal units (Btu) per hour:
v Minimum configuration: 341 Btu per
hour (100 watts)
v Maximum configuration: 1024 Btu
per hour (300 watts)
Electrical
input:
v Sine-wave input (50 - 60 Hz)
required
v Input voltage low range:
– Minimum: 100 V ac
– Maximum: 127 V ac
v
Input voltage high range:
– Minimum: 200 V ac
– Maximum: 240 V ac
v
Approximate input kilovolt-amperes
(kVA):
– Minimum: 0.102 kVA
– Maximum: 0.55 kVA
Notes:
1. Power consumption and heat
output vary depending on the
number and type of optional
features that are installed and the
power-management optional
features that are in use.
2. These levels were measured in
controlled acoustical environments
according to the procedures that
are specified by the American
National Standards Institute (ANSI)
S12.10 and ISO 7779 and are
reported in accordance with ISO
9296. Actual sound-pressure levels
in a given location might exceed
the average stated values because
of room reflections and other
nearby noise sources. The declared
sound-power levels indicate an
upper limit, below which a large
number of computers will operate.
3. There is no keyboard connector or
mouse connector on the server.
You can connect a USB keyboard
and USB mouse to the server by
using the USB connectors.
4 ThinkServer RS110 Types 6435, 6436, 6437 and 6438: User Guide