Filter
Top Products
Note: If this LED is off, it does not mean that there is no electrical power in the
server. The LED might be burned out. To remove all electrical power from the
server, you must disconnect the power cord from the electrical outlet.
Power-control button: Press this button to turn the server on and off manually. A
power-control-button shield comes installed around the button to prevent the server
from being turned off accidentally. You can remove this disk-shaped shield if you
prefer.
Reset button: Press this button to reset the server and run the power-on self-test
(POST). You might have to use a pen or the end of a straightened paper clip to
press the button.
Hard disk drive activity LED: When this LED is flashing, it indicates that a hard
disk drive is in use.
Locator LED: This LED can be lit remotely by the system administrator to aid in
visually locating the server.
Rear view
The following illustration shows the LEDs on the rear of the server.
1 Ethernet 1 activity LED 3 Ethernet 2 activity LED
2 Ethernet 1 link LED 4 Ethernet 2 link LED
Ethernet activity LED: This LED is on each Ethernet connector. When this LED is
lit, it indicates that there is activity between the server and the network.
Ethernet link LED: This LED is on each Ethernet connector. When this LED is lit, it
indicates that the Ethernet controller is connected to the network.
The following illustration shows the connectors on the rear of the server.
1 Power-cord connector 5 Ethernet 1 connector
2 Systems-management connector 6 Ethernet 2 connector
3 USB 3 connector 7 Video connector
4 USB 4 connector 8 Serial connector
Power-cord connector: Connect the power cord to this connector.
8 ThinkServer RS110 Types 6435, 6436, 6437 and 6438: User Guide