Filter
Top Products
Rear
1 Power-cord connector 5 Ethernet 1 connector
2 Systems-management connector 6 Ethernet 2 connector
3 USB 3 connector 7 Video connector
4 USB 4 connector 8 Serial connector
You must turn off the server before you connect or disconnect cables.
See the documentation that comes with any external devices for additional cabling
instructions. It might be easier for you to route cables before you connect the
devices to the server.
Cable identifiers are printed on the cables that come with the server and devices.
Use these identifiers to connect the cables to the correct connectors.
If the server comes with an installed operating system, see the documentation that
comes with the operating system for additional cabling instructions.
There is no keyboard connector or mouse connector on the server. You can
connect a USB keyboard and USB mouse to the server by using the USB
connectors.
Updating the server configuration
When you start the server for the first time after you add or remove an internal
optional device or external SAS device, you might receive a message that the
configuration has changed. The Configuration/Setup Utility program starts
automatically so that you can save the new configuration settings. For more
information, see Chapter 3, “Configuring the server,” on page 37.
Some optional devices have device drivers that you must install. For information
about installing device drivers, see the documentation that comes with each device.
If the server has a RAID configuration that uses the SAS/SATA controller with
integrated RAID (hot-swap SATA or SAS models only) and you have installed or
removed a hard disk drive, you might have to reconfigure the disk arrays.
If the server has an optional RAID adapter and you have installed or removed a
hard disk drive, see the documentation that comes with the RAID adapter for
information about reconfiguring the disk arrays.
If the server is a simple-swap model that contains a SATA RAID back plate, you can
use the LSI Logic Configuration Utility program to configure the simple-swap SATA
hard disk drives.
For information about configuring an integrated Gigabit Ethernet controller, see
“Configuring the Gigabit Ethernet controllers” on page 46.
36 ThinkServer RS110 Types 6435, 6436, 6437 and 6438: User Guide