Filter
Top Products
Important: Use only a supported SAS/SATA controller in the SAS/SATA controller
card connector. For a list of supported optional devices for the server, see
http://www.lenovo.com/thinkserver.
System-board switches and jumpers
The following illustration shows the switches and jumpers on the system board.
1 Boot block recovery jumper
2 Clear CMOS jumper
The following illustration identifies the pins on a jumper and shows the location of
pin 1.
3
2
1
Pin 1 mark
Table 2. Switch and jumper settings
Component Settings
Clear CMOS jumper (JP3)
v Pins 1 and 2: Keep CMOS data (default)
v Pins 2 and 3: Clear the CMOS data, which clears the
power-on password and administrator password
Boot block jumper (JP4)
v Pins 1 and 2: Normal (default)
v Pins 2 and 3: Boot from boot block
Chapter 2. Installing optional devices 15