Filter
Top Products
8
LEDs will soon flash red.
When the Switch passes the self-test within 15 seconds, the Link
/ACT LED turns on.
Note : If the Switch fails the self-test, the Diag LED will blink.
3.
Connecting to the Network
This section provides the installation procedure and instructions for
assigning IP address.
Pre-Installation Requirements
Before you start hardware installation, make sure your installation
environment has below items:
PCs with 10/100Mbps Ethernet NICs/ 100Mbps Fiber NICs:
Your PC must have a standard Ethernet interface to connect to
the Switch.
UTP cable with RJ45 connectors/ Fiber cable with MT-RJ/
VF-45 connectors: Check if the cable and connectors work
properly.
A power outlet: 100 to 240V AC at 50 to 60 Hz: Make sure
that the Switch power is accessible and cables can be
connected easily.