Filter
Top Products
Diagnostic Information 2-12
4040 Finisher
Paper Feed Motor Service Check
Paper Jam, 41, Paper Input Service Check
Clear all paper from the paper deck, printer, and finisher. If there is
no paper you must open and close one of the finisher covers to clear
the error.
1 Connector Be sure the J10 is properly connected to the
finisher driver board.
2 Paper Feed
Motor, M1, (4-
43)
Unplug J10 from the finisher driver board. Measure
the resistance between J10-1 and J10-4/ -6 and
between J10-2 and J10-3/ -5 on the motor side. If it
does not read 4.3 Ohms, replace the paper feed
motor (PN 11D0118).
3FinisherDriver
Board (13-1)
If there is still a problem, replace the finisher driver
board (PN 11D0294).
1 Input Paper
Sensor Flag
(1-4)
Open the right access door and check the
operation of the flag (PN 11D0015) for the paper
input sensor (PI-1).
2 Input Paper
Sensor, PI-1,
(3-10)
Check the voltage of J13-3 on the finisher driver
board. There should be 5 V when the sensor is
activated (PN 11D0071).
3FinisherDriver
Board (13-1)
If there is still a problem, replace the finisher driver
board (PN 11D0294).