Filter
Top Products
Diagnostic Information 2-16
4040 Finisher
Stapler Motor Service Check
Stapler Shift Motor Service Check
1 Connector Be sure J8 is properly connected to the finisher
driver board.
2 Stapler Motor Unplug J8 from the finisher driver board. Measure
the resistance between J8-11 and J8-12 on the
motor side. If it does not read 10 Ohms, replace the
stapler motor assembly (PN 11D0344).
3FinisherDriver
Board (13-1)
If there is still a problem, replace the finisher driver
board (PN 11D0294).
1 Connector Be sure J8 is properly connected to the finisher
driver board.
2 Staple Shift
Motor, M4 (12-
5)
Unplug J8 from the finisher driver board. Measure
the resistance between J8-5 and J8-1/-2/-3/-4 on
the motor side. If it does not read 16.5 Ohms,
replace the staple shift motor (PN 11D0269).
3FinisherDriver
Board (13-1)
If there is still a problem, replace the finisher driver
board (PN 11D0294).