Diagnostic Aids 3-3
4098-001
End of Forms (EOF) Test
To Start the Test:
• Unplug power to the printer.
• Remove the rear cover.
• Placea2pinjumperonJ13.
• Hold down the Power and Paper Feed buttons.
• Plug power to the printer.
• Release the buttons when the Power Light flashes
(approximately 5 seconds).
To Test:
• Place a piece of paper in the manual feeder to activate the end-
of-forms sensor.
• The Busy Light will come on when the flag is removed from the
sensor and will be off when the flag is in the sensor.
• Unplug the printer power or press the Power button to end
the test.
• Remove the jumper from J13.