Diagnostic Aids 3-5
4098-001
Clear NVRAM
To Run:
• Unplug power to the printer.
• Remove the rear cover.
• Placea2pinjumperonJ14
• Place a sheet of paper in the manual sheet feeder far enough to
activate the paper sensor.
• Open the access cover.
• Hold down the Power and Paper Feed buttons.
• Plug power to the printer.
• Release the buttons when both the Power and Busy Lights turn
on.
• After approximately 20 seconds, the Power Light will flash.
• Power off the printer to exit the test.
• Remove the jumper from J14.
What Happens:
• The following will be reset to zero:
– Last Error
– Page Count
– Carrier Metric
– Drop Count (Color and Black)