A SERVICE OF

logo

Replacing the access cover plate
27
Step 12: Installing memory, option, or interface cards
4 Align the connection points on the card with the connector on the system board, and then push the top of the card
firmly into the system board connector.
5 Insert and tighten the screws to secure the card.
Replacing the access cover plate
After you have installed options on the printer system board, follow these steps to reattach the access cover plate.
1 Align the slots at the top of the access cover with the screws near the top of the printer.
2 Slide the cover up under the top cover lip as far as it will go.
3 Insert and tighten the (four) screws at the top and bottom of the cover.