Lexmark E310 Printer User Manual


 
2-28 Service Manual
4044-XXX
Paper "trees", wrinkles, stacks poorly or curls
Print Quality Service Check
Blank page
FRU Action
Models E310 & E312
Transfer Roller
This problem is most likely due to a
worn transfer roller. A worn transfer
roller causes the printer to run hotter
than required for the media being
printed. Excessive heat can cause
paper treeing problems, poor
stacking or curl.
FRU Action
Models E310 & E312
Toner Cartridge
Remove the toner cartridge and
gently shake the assembly to evenly
distribute the toner.
Printhead
Printhead Cable
HVPS
Engine/LVPS Board (Model E310)
Engine Board (Model E312)
Blank pages can be caused by a
defective printhead assembly, high
voltage power supply or engine/
LVPS board. Disconnect the
printhead cable from the HVPS and
measure the signals on connectors
CN3 and CN4. Go to the High
Voltage Power Supply (model E310)
on page 5-16 in the connector
locations chapter and check the
voltage measurements. If the
voltages are correct, check the
printhead cable for continuity. If the
cable measures continuity, replace
the printhead. If the cable does not
measure continuity, replace the
cable. If the voltage measurements
are not correct, replace the HVPS. If
the problem still exists, replace the
engine/LVPS board on the model
E310 or the engine board on the
model E312.