Filter
Top Products
35
ENG
English
Using CLOUD Solution
y
Prefer GSC-IS
If this option is selected, the GCS-IS interface
is used when a smart card supports more than
one interface. If the smart card supports only
one interface, it is not used.
y
Enable Peer Loss Overlay
If this option is selected, the "Network Con-
nection Lost" message is displayed on the
screen when it is confirmed that the network is
disconnected.
The display is the same as in the VDI environ-
ment. The default is Disable.
y
Enable Preparing Desktop Overlay
If this option is selected, the "Preparing Desk-
top" message is displayed on the screen when
the user is logged in.
y
Disconnect Message Filter
This option determines the type of message to
display when a session is disconnected.
- Show All: Shows all the error messages.
- Show Error and Warning Only: Shows the
error and warning messages only.
- Show Error Only: Shows the error messages
only.
- Show None: Shows nothing.
y
Desktop Name to Select
Enter the name of the pool/desktop which the
user client uses upon starting a session.
y
Port
For the default setting, leave the port field
empty. When the VMware View Connection
Server uses the SSL authentication, enter 443
in the Port field.
If the server where a user tries to access uses
a port other than a general port, enter the port.
y
Auto Connect
If this option is enabled, the selected VMware
View Connection Server is automatically con-
nected when the user client is powered on.
If the Auto Connect option is enabled, you
should turn the user client off and turn it on
again at least once.
y
Remember Username
If this option is selected, the username which
is previously used to access the VMware View
Connection Server is automatically entered in
the username field.
y
Auto Launch if Only One Desktop
If this option is selected, connection is estab-
lished to the desktop when there is only one
virtual desktop that a user wants to access.
y
Use OSD logo for View banner
If this option is enabled, you can change the
OSD logo of PCoIP during the login.
<Figure 2-17: Advanced Settings for View Connection
Server>
y
The OSD logo can be uploaded using the
Webpage Administration Interface.
NOTE
y
This setting is provided only when a smart
card is used.
NOTE
y
This setting is provided only for the client.
NOTE