Filter
Top Products
Operation 77
Separate / Simultaneous Outputs
The RS-232 interface can support a modem plus either a local terminal or a local monitor. Likewise, the SiteScan
port can support either SiteScan or SNMP communications. Whatever interfaces you use will all operate simulta-
neously.
Table 3 Series 600T Terminal Commands
Key( s) Function
A, retur n
AN (N=1 to 6), return
Displays Present Status Report screen. NOTE: For all three report screens, a
number 1 through six in place of N will access an individual UPS module. If no
number is entered, you will get a report from the SCC.
^B (control-B), return
^BN (N=1 to 6) return
Displays Event History Report screen, starting with t he most recent frame and then
scrolling back through earlier frames.
C, retur n
^CN (N=1 to 6), return
Displays History Status Report screen starting with the most recent frame and then
scrolling back through the earlier frames.
F (no return) Freezes data output. This stops the data scrolling on the monitor to allow closer
study or a printout. This is a toggle switch command. Press the F key again t o
resume data scrolling.
G, return Resets (unfreezes and clears) the History Status Report memory buffer. This erases
the alarm messages and meter indications that were stored immediately before and
after a significant system fault. NOTE: Do not reset the History Status Report
memory buffer until operation and maintenance personnel have reviewed it as a
troubleshooting tool.
Q (no return) The data output stops (quits). The UPS communication system remains on stand-
by, ready to receive the next communication command. NOTE: To return to the
beginning of the Event History or History Status Report, press Q, then request your
desired report again.
d mm/dd/yy, return This entry sets the date (month/day/year) in the UPS system clock. You must
include the slash (/) as you key in the date. Note that the d command must be lower
case.
t hh:mm:ss, return This entry sets the time (hour:minute:second) in the UPS system clock. You must
include the colon (:) as you key in the time. Note that the t command must be lower
case.
H, Return Prompts the UPS system to hang up its modem (only applicable to the modem
communications port).
I, Return Display Battery Cycle Monitor information for 0-30 second discharge events.
J, Return Display Battery Cycle Monitor information for 31-90 second discharge events.
K, Return Display Battery Cycle Monitor information for 91-240 second discharge events.
L, Return Display Battery Cycle Monitor information for over 240 second discharge events.
M, Return Display St atus Summary screen of battery discharge events.
N, Return Show detail information on all battery discharge events in order of occurrence
(Last-In, First-Out).
backspace Moves cursor left to cancel previous entry or command.
DISCONTINUED
PRODUCT