Filter
Top Products
2 Configurations
2.1 Port Status
This page provides the current link status for all ports. You can select the Port Status menu to
activate this page and to refresh the current port status.
This page provides the following information:
Port – to specify a port on the switch
Link Status – to show the port link status: Up / Down
Speed / Duplex – to show the current link speed (1G / 100M / 10M bps) and duplex mode
(Full / Half) while the port is linkup.
NOTE: Only the full duplex mode is supported while the link speed is 1Gbps.
Flow Control – to show the flow control capability is Enable / Disable for this port.
The status for the two columns: Speed/Duplex and Flow Control won’t show up while the port link
is down. (The sign ‘-‘ represents the status is unavailable to display.)
If any trunk group is setup, a trunk group can be regarded as one logical port (e.g. Trk1 in the above
figure is grouped by Port9 & Port10) which will show up just like the others. All the trunk member
ports won’t be displayed. Section 2.7 (Trunk) describes port trunking in detail.
Click the Refresh button to manually get the most current link status for all ports.
8