Lindy CPU IP Access Switch Plus Switch User Manual


 
 




15
Resetting the conguration
The CPU IP asks for an unknown admin password
This may occur if the CPU IP has been previously congured. If the existing
admin password cannot be discovered, then your only recourse is to perform a
factory reset.
To invoke a conguration reset by switch
1 Remove power from the CPU IP unit.
2 At the rear of the CPU IP, adjacent to the power input socket, click mini
switch 1 to its ON (down) position.
3 Re-apply power to the CPU IP. On the locally connected monitor you should
see a Maintenance menu:
Maintenance
Reset Configuration
return to normal operation.
Configure Network
Put option switch 1 up t
o
To upgrade unit, visit:
http://192.168.42.154
Reset Config
DO YOU WISH TO CONTINUE?
CancelRESET
WARNING: Continuing will cause
your existing configuration to
be erased.
The unit will then reset and
require re-configuring before
it can be used.
4 Select the ‘Reset conguration’ option.
A warning screen will be displayed. Select the RESET option and press .
5 Remove power, return the mini switch 1 to its OFF position and then re-
apply power. The locally connected monitor should display the rst screen of
the initial conguration sequence.
The CPU IP does not display the conguration sequence
If the CPU IP has been previously congured it may not automatically display the
rst of the setup screens. In this case you have two options, either:
• Access the Unit, Network and Serial conguration screens separately, or
• Reset the conguration:
To invoke a conguration reset by main menu
1 Using the locally connected keyboard and screen, log on as the admin user.
2 Select the ‘Conguration’ option.
Configuration
Reset Configuration
Back
Modem Configuration
Network Configuration
Unit Configuration
3 Highlight the ‘Reset conguration’ option and press .
A warning screen will be displayed, select the RESET option and press .
Reset Config
DO YOU WISH TO CONTINUE?
CancelRESET
WARNING: Continuing will cause
your existing configuration to
be erased.
The unit will then reset and
require re-configuring before
it can be used.
4 The CPU IP will reset and then display the rst of the four initial
conguration screens.