Filter
Top Products
Novell NetWare Setup
The instructions below cover the following versions of
Novell NetWare:
· NetWare workstations for DOS & Windows 3.x
· Client32 for Windows 95 & Windows 98
· 3.12, 4.x, and 5.0 NetWare Servers
If you have a version or type of NetWare not shown
above, run the README program on the EtherFast
Card disk to obtain the installation instructions for your
version. See page 10 for more information about the
README.
Installing NetWare Workstations for DOS (6.22
or higher) and Windows 3.x Users
The installation of the EtherFast Card's Novell worksta-
tion drivers is accomplished with a program on the
EtherFast Card disk called DIAG. DIAG will copy the
appropriate network drivers to your computer, generate
a NetWare NET.CFG file, and automatically update
your AUTOEXEC.BAT and CONFIG.SYS system files.
DIAG also comes with a built-in diagnostic feature that
allows you to test the EtherFast Card's functionality at
any time. For more instructions on testing the card, see
the Troubleshooting section at the end of this guide.
1. Start up your computer in DOS. Insert the EtherFast
Card disk into drive A.
2. From the DOS command prompt (C:\>), type the fol-
lowing commands one-by-one. Press the Enter key
after each command:
a:install
35
NetWare