Filter
Top Products
Installing a 3.12 Server
The EtherFast Card network driver is installed during
the NetWare installation process. During the setup you
may want to refer to your NetWare 386 v3.12
Installation Manual for help. You will also be using
ConfigDisk during the setup.
1. Make a directory in the DOS partition of your file
server called LNE100.
2. Copy the following files from the card’s disk 2 to
your file server's new LNE100 directory:
a:\netware\server\3.12\NBI31X.NLM
a:\netware\server\3.12\MSM31X.NLM
a:\netware\server\3.12\ETHERTSM.NLM
a:\netware\server\3.12\LNE100TX.LAN
3. Following the Load LAN Driver Module instructions
in your Novell NetWare 386 v3.12manual, start
NetWare and configure the server if you haven’t
already.
4. Load the LAN drivers above using the LOAD com-
mand.
If the LAN driver is not located in the default directory,
specify the file's path on the command line. The LOAD
command prompts you for the configuration parameters
if they are not supplied on the command line.
You can save the LOAD command line parameters in a
file with the name AUTOEXEC.NCF so they execute
automatically when the server starts. See the Novell
NetWare 386 v3.12 Installation Manual for details on
how to create the AUTOEXEC.NCF file.
41
NetWare