Filter
Top Products
To configure a Point to Point bridged environment:
1. Click Point to Point.
2. Set the MAC Address of the Access Point in LAN 1 to look for the
MAC Address of the Access Point in LAN 2.
3. Set the MAC address of the Access Point in LAN 2 to look for the
MAC Address of the Access Point in LAN 1.
4. On the Operational Mode tab, enter the Remote MAC Address of the
remote Access Point. The remote Access Point also needs to be set up
as a Wireless Bridge.
Note: All devices on each LAN must be connected through a hub or switch.
Point to MultiPoint
This mode allows you to construct a network that has multiple WAP11 units
bridging wirelessly.
• Access Point Client -
A WAP11 set to Access
Point Client mode is
able to talk to one main
WAP11 and wireless
clients within its range.
This mode allows your
WAP11 to act as a client
of a main WAP11. A
LAN attached to your
WAP11 client can then
be wirelessly bridged to
the main WAP11. Enter
the required MAC
address of the main
WAP11.
• Wireless Bridge - If you are trying to make a wireless connection between
two or more wired networks, select Wireless Bridge. There are two options:
Point to Point and Point to MultiPoint.
Point to Point
This mode connects two physically separated LAN segments by using two
WAP11 units.
Instant Wireless
TM
Series
Wireless Network Access Point
24 25
Note: In Wireless Bridge mode, the WAP11 can ONLY be
accessed by another wireless bridge. In order for your other
wireless devices to access the WAP11, you must reset it to
Access Point mode. The two modes are mutually exclusive.