Filter
Top Products
39
Chapter 5: Configuring the Wireless-G Broadband Router with 2 Phone Ports
The Status Tab - Router
Wireless-G Broadband Router with 2 Phone Ports
The Status Tab - Router
The Router screen on the Status Tab displays the Router’s current status.
Firmware Version. This is the Router’s current firmware.
Current Time. This shows the time, as you set on the Setup Tab.
MAC Address. This is the Router’s MAC Address, as seen by your ISP.
Router Name. This is the specific name for the Router, which you set on the Setup Tab.
Host Name. If required by your ISP, this would have been entered on the Setup Tab.
Domain Name. If required by your ISP, this would have been entered on the Setup Tab.
Configuration Type. This shows the information required by your ISP for connection to the Internet. This
information was entered on the Setup Tab.
DHCP Release. Available for a DHCP connection, click this button to release the current IP address of the device
connected to the Router’s Internet port.
DHCP Renew. Available for a DHCP connection, click this button to replace the current IP address—of the device
connected to the Router’s Internet port—with a new IP address.
Figure 5-45: Status Tab - Router