LSI 22903 Server User Manual


 
8 LSI22902/22903 Host Adapter to Intel ISP1100 Internet Server
2.2.2 LSI22902 Installation Method 2
Method 2 is different from the first method in that you remove the riser
card from the ISP1100 to insert the LSI22902/22903, rather than doing
it in place as in Method 1. Refer to Figure 7 for a photograph showing
the host adapter installed in the riser card.
Step 1. Attach the hard drive LED cable to the SCSI host adapter card.
Use either pin pairs 1-2 or 3-4, as shown in the inset in
Figure 7.
Step 2. Gently remove the riser card from the server board connector.
Step 3. Plug the SCSI card in the right slot on the riser card.
Step 4. Press the riser with the installed SCSI card straight down into
the mating connector on the server board.
With the card properly inserted, the SCSI card bracket rests in
the tab on the back of the chassis. There is no screw securing
the card guide bracket in place as in a PC.
Step 5. Secure the expansion bay retention clip with the two previously
removed screws.