Filter
Top Products
4-4 BIOS Features
Copyright © 2002 - 2005 by LSI Logic Corporation. All rights reserved.
ENTER, the FC Link bus is scanned and the Adapter Properties screen
appears.
On the Main menu, two selections are the Boot Adapter List and
Global Properties menus.
Boot Adapter List allows selection and ordering of boot adapters. Refer
to Section 4.4.4, “Boot Adapter List Menu,” for details.
Global Properties allows changes to global scope settings. Refer to
Section 4.4.5, “Global Properties Menu,” for details.
Only host adapters with LSI Logic Control enabled can be accessed.
4.4.1 Adapter Properties Menu
The Adapter Properties menu allows you to view and modify adapter
settings. It also provides access to the device settings of a host adapter.
To display this menu, select a device under the Adapter field on the
Main menu and press ENTER.
4.4.2 Persistent ID Menu
You can use the Persistent ID menu simply to review the automatic
mapping between a drive World Wide Name (WWN) and its assigned
logical SCSI bus and Target ID. The screen also can force a drive to a
specific logical Target ID.
Selecting Add WWN at an unused location clears out the associated
WWN/DID field and allows you to enter the first 16 characters of the
WWN. Pressing ENTER afterwards allows the last 16 characters to be
entered. The Configuration Utility automatically adds any leading zeros,
if necessary. If an entry was put in by mistake, selecting Erase on the
appropriate line removes the entry.
Logical ID selection defaults to be the lowest ID available. This can be
changed by using the PLUS or MINUS keys to cycle the numbers. The
Bus field always defaults to 0 and cannot be changed. It is displayed
whenever an outside utility has reserved a different number.
The Next Page and Previous Page options are provided on the persistent
ID screens through the F2 key, which moves the screen forward or back
by 16 entries. However, the CU requires storing any modifications to the