Filter
Top Products
4-10 BIOS Features
Copyright © 2002 - 2005 by LSI Logic Corporation. All rights reserved.
/upa@8,480000/SUNW,ffb@0,0
...
/pci@8,700000/IntraServer,fc@2
/pci@8,700000/IntraServer,fc@1,1
/pci@8,700000/IntraServer,fc@1
...
/pci@8,700000/IntraServer,fc@2/disk
/pci@8,700000/IntraServer,fc@2/tape
/pci@8,700000/IntraServer,fc@1,1/disk
/pci@8,700000/IntraServer,fc@1,1/tape
/pci@8,700000/IntraServer,fc@1/disk
/pci@8,700000/IntraServer,fc@1/tape
/pci@8,700000/scsi@6,1/tape
/pci@8,700000/scsi@6,1/disk
ok
• /pci@8,700000/IntraServer,fc@1
identifies the first FC interface on an LSIFC929X-based adapter.
• /pci@8,700000/IntraServer,fc@1,1
identifies the second FC interface on an LSIFC929X-based adapter.
• An LSIFC919X-based adapter shows only one such FC device.
Note: The above listing is an example. The show-devs output
may vary depending on your system and configuration. Use
the corresponding entries on your system, not the ones
given here.
If these devices are not listed, check to assure that the adapter is
correctly installed and reseat the adapter in the PCI slot if necessary.
4.7.4 Adapter-Specific Settings
In certain circumstances, advanced users may want to change settings
for an individual adapter or port, without affecting the other adapters in
the system. Specific examples of such settings are FC bus speed, host
adapter ID (SCSI only: not applicable to FC), and Interrupt Coalescing.
To select a specific Fusion-MPT adapter as the current adapter, use the
select command. Selecting a port or adapter brings the port online and
allows you to show or set certain adapter specific parameters.