Filter
Top Products
3-18 October 22, 1999 SP Switch Router Adapter Guide - 1.4 Update 2
Monitoring and Management Tools
SP Switch Router Adapter card maint commands
[RX] Switch Transmit Connection Rejects: 0
[RX] Switch Receive Encoding Errors: 0
[RX] Switch Receive Running Disparity Errors: 0
[RX] Switch Receive Receiver Errors: 0
[RX] Switch Receive Running Checksum Errors: 0
[RX] dont-free packets: 0
[RX] fifo-full packets: 0
maint 6 - display combus statistics
To look at information about the exchanges between the system software and the SP Switch
Router Adapter card, enter maint 6 for the receive side and maint 106 for the transmit side.
GR 07> maint 6
[RX] Combus Status:
[RX] Last interrupt status: 0x50502055
[RX] Combus Statistics:
[RX] Message ready interrupts: 16153
[RX] Truncated input messages: 0
[RX] Grit messages for TX-CPU: 155
[RX] Ip messages Rcvd (non-bypass): 0
[RX] Raw messages: 0
[RX] ISO messages: 0
[RX] Grid messages: 15998
[RX] Grid echo requests: 15865
[RX] Port available messages: 0
[RX] Segmented Packets: 0
[RX] Segments Sent: 0
[RX] Combus Errors:
[RX] Bus in timeouts: 0 Bus out timeouts: 0
[RX] Out of buffer cond.: 0 Bad packet type: 0
[RX] Dropped IP packets: 0 Bad packet dest: 0
[RX] Receive Msg Errors: 0 Receive Format Errors: 0
[RX] Receive Past End: 0 Received Long Message: 0
Filtering commands - maint 50-58, 150-58
Odd-numbered commands 51–55 return information based on filter ID. Even-numbered
commands 50–54 return information based on interface number. These are parameters added to
some filter commands:
– detail_level is an optional parameter that specifies how much information is
returned, useful levels are 0 and 1.
– IF is an optional parameter that specifies the interface number.
– ID is an optional parameter that specifies the filter ID randomly assigned by filterd.
[RX] 50: Filtering filter list: [detail_level [ID]]
[RX] 51: Filtering filter list: [detail_level [IF]]
[RX] 52: Filtering action list: [detail_level [ID]]
[RX] 53: Filtering action list: [detail_level [IF]]
[RX] 54: Filtering binding list: [detail_level [ID]]
[RX] 55: Filtering binding list: [detail_level [IF]]
[RX] 56: Display filtering statistics: [IF#]
[RX] 57: Reset filtering statistics: [IF#]
[RX] 58: Show filter protocol statistics