Filter
Top Products
MAGMA
15
Shutting Down:
STOP
DO NOT TURN OFF THE MAGMA EXPANSION CHASSIS UNTIL
YOU HAVE SHUT DOWN YOUR COMPUTER COMPLETELY! It
can cause a system lockup and loss of any unsaved data.
When shutting your system down, it is recommended that you first shut
down the computer correctly, and then power down the Magma
expansion chassis to avoid ‘computer lock-up’ and potential data loss.
Rack Installations (for the EB2R model)
Locate a vacant 1U slot in your rack that is within the reach of the iPass
data cable provided with your EB2 Expansion System. Install the rails in
the rack as shown below:
Measure the rack from front to
back so you can confirm how
long the rail must be to fit
properly.
Next, assemble the Slide piece with the end bracket as shown and
secure with 2 Panhead screws and locking nut. Ensure the Phillips
screw head is located on the “open” side of the Slide pieces as shown.
Tighten finger tight only to allow for minor
adjustment during assembly.
Depending on the depth of your rack you
may select either the long or the short end
bracket.
Add Screws to Rack Post
Attach 2 Panhead screws into the rack post where you want the chassis
mounted. Be sure you have measured accurately to ensure that
everything fits in the rack correctly. Leave the screws untightened until
after you place the slide rail’s fingers between the screws as shown.