6
INSTALLATION INSTRUCTIONS (continued)
Installation and Cabling
Connecting to a PC
● Read SAFTEY GUIDELINES ( to ) carefully to ensure maximum safety before
proceeding to these steps:
1) Make sure that the display signals produced by your PC meet the specifications of this
product.
■ For the specifications of this product, see Product Specifications ( to ).
2) Choose an appropriate site and install the product on a level table where the stand is secure.
■ Install the monitor to have ready access to a power socket.
3) Make sure that your PC’s power switch is off.
4) Interconnect the signal input terminal (RGB1) on the monitor rear panel and the display
signal output terminal of the PC to each other using the signal cable included.
■ Optional cables are needed to connect to the RGB2 input and audio input terminals.
■ If the signal cable included does not match your PC, consult your dealer after reading the section
“Signal Input”.
5) Insert one end of the power cable included into the rear-panel power cable connector and the
other end into a mains.
6) Turn on the monitor, then the PC to make sure that a display image appears on the monitor
screen.
■ For instructions on turning on the monitor and adjusting its display images, see “Operating
Instructions”
( to ).
RS232C IN
L/MONO
RGB2
RGB1
D-SUB IN
AUDIO IN
R
RGBHV
Nearer Terminal
Further Terminal
Monitor rear panel
Power
cable
Power cable
connector
PC
To signal input
terminals
To audio input
terminals
To signal input
terminals
To audio output
terminal
To signal output
terminal
To signal output
terminal
26 27
9
17
27
ENGLISH