Filter
Top Products
ENGLISH
iii
Fire or electric shock may cause death or serious injury unless you
follow the instruction.
Warning
● The enclosed power cord must be used!
Failure to do so may cause electric shock hazard or fire hazard.
In
USA/Canada, use a UL LISTED/CSA LABELLED or CERTIFIED power cord set
meeting the following specifications :
Rating: min. 125V, 10A , Length: max. 3.0m , Type: SVT or SJT
Plug type: NEMA 5-15P figure, Parallel blade, Grounding type
In
Europe or 200V area, a proper European standard approved power cord is to be
used with this monitor.
For a rated current up to 6 A, a type not lighter than H05VV-F 3G 0.75 mm2 or
H05VVH2-F 3G 0.75 mm2 must be used.
● Use only the correct voltage power outlet with safety ground connection!
100 - 120 V for USA, Canada, etc.
200 - 240 V for Europe, etc.
(This monitor will automatically adjust to the input voltage 100 - 120 / 200 - 240V.)
● Be careful of power cord connection!
Before inserting the plug of the power cord into a socket of the correct voltage, check
that the connection portion of the power cord is clean (with no dust). Then, insert the
plug of power cord into the socket firmly, otherwise it may cause electric shock or fire
hazard.
● Do not touch the power plug when lightning is close to you.
You may receive an electric shock.
● Do not touch the power plug with wet hands.
You may receive an electric shock.
● Do not obstruct a ventilation hole.
If you obstruct a ventilation hole during the operation of the monitor or just after
switching off the power, it may cause a fire or electric shock due to heating up the
monitor.
• Do not put the monitor screen side up.
• Do not put the monitor on a shelf or in a cabinet.
• Do not put the monitor on a carpet or mattress.
• Do not cover the monitor with a cloth.