LTRx-512 Installation and User’s Guide
16
3G – Setup Communication
The “factory default” communication settings (LTR8-512 and LTR8-512M only) are:
Baud Rate: 9600
Terminal ID#: 065
Use Function [B] (described on Pg. 30) if you if you need to change these settings for MasterLink
configurations involving multiple Masters,
You can setup your LTR8-512 with LTR MasterLink using RS-232 (serial), RS-485 (networked), Modem
(remote), or Ethernet (requires TXTOSER accessory) Communications.
You must enter these same settings for your LTR8-512 in the LTR MasterLink software
Congratulations! You have finished the basic setup of your LTRx-512 Master.
Basic Setup is Complete!
All of the programmed parameters have been stored in the Master’s protected memory and will be
retained in the event of power failure, brown-outs, etc.
The Master will exit itself out of Program Mode once you stop using the keypad for 5 minutes. If you
wish to exit programming mode immediately, to prevent others from accessing the Master Clock, simply
enter an invalid password. (For example)
Press Display
[#] SELECT FUNCTION CODE
[0] [0]=ENTER PASSWORD
[#] 99 [#] PASSWORD: 000099