LTRx-512 Installation and User’s Guide
21
[2]=Select Clock Control
This function requires the administrator password
Use this function to choose the make/model of the clocks that your Master will synchronize (Note:
The LTR4-512 can only synchronize one type of secondary system)
Enter your administrator password, then start this function by pressing [#][2][#]
Enter the 2-digit code for CLOCK1, then press [#]. If you entered a code other than ‘00’, and you have
a LTR8-512 or LTR8-512M, you will see
Enter the code for CLOCK2, or [0][0] if you will not use a CLOCK2, then press [#]
PRESS [#] IF CORRECT
Enter [#] to confirm or [*] to cancel and try again
[3]=Manual Bell Control
This function does not require a password
Use this function to test bell circuits or to sound a bell during an unscheduled time, such as a fire
alarm. Press [#][3][#] to start this function
The 2
nd
line of the display only shows the circuit numbers (1-8) that are available for bell controls
MANUAL BELL CONTROLS
1-2-3-4-5-6-7-8
PRESS AND HOLD [#]
TO EXECUTE.[*]TO END
ENABLE CLOCK CIRCUIT
SELECT CLK1 CODE: NN
[#] FOR CODE LIST
ENABLE CLOCK CIRCUIT
SELECT CLK2 CODE: NN
[#] FOR CODE LIST