Measurement Specialties PCI-DAS64/M2/16 Computer Hardware User Manual


  Open as PDF
of 36
 
PCI-DAS64/M2/16 User's Guide Specifications
Analog output pacing and triggering
Table 12. Analog output pacing and triggering specifications
Internal counter – ASIC
External source (D/A external pacer)
D/A pacing
(software-programmable)
Software paced
External digital (external D/A trigger/pacer gate)
D/A gate sources
(software-programmable)
External analog (analog trigger in)
External digital: Programmable, active high or active low, level or edge D/A gating modes
External analog: Software-configurable for above or below reference. Gating levels are
set by DAC0 or DAC1.
External digital (external D/A trigger/pacer gate) D/A trigger sources
Software triggered
D/A triggering modes External digital: Software-configurable for rising or falling edge.
From 16 k RAM buffer via DMA (demand or non-demand mode) using scatter gather.
Programmed I/O
Data transfer
100 kS/s max per channel
Digital input/output
Table 13. Digital I/O specifications
Output: 74LS175
Digital type (main connector)
Input: 74LS244
Configuration Four inputs, four outputs (DIN0 through DIN3; DOUT0 to DOUT3)
Output high voltage (IOH = -0.4 mA) 2.7 V min
Output low voltage (IOL = 8 mA) 0.5 V max
Input high voltage 2.0 V min, 7 volts absolute max
Input low voltage 0.8 V max, –0.5 volts absolute min
Digital type (digital I/O connector) 82C55
Number of I/O 24 (FIRSTPORTA Bit 0 through FIRSTPORTC Bit 7)
2 banks of 8 and 2 banks of 4, or
3 banks of 8 or
Configuration
2 banks of 8 with handshake
Input high voltage 2.0 V min, 5.5 V absolute max
Input low voltage 0.8 V max, –0.5 V absolute min
Output high voltage (IOH = -2.5 mA) 3.0 V min
Output low voltage (IOL = 2.5 mA) 0.4 V max
Power-up / reset state Input mode (high impedance)
SSH output
TTL compatible output, HOLD is asserted from start of the conversion for
Channel 0 through conversion of the last channel in the scan. Available at user
connector (SSH OUT / D/A PACER OUT). This pin is software selectable as
SSH OUT (default) or D/A PACER OUT.
SSH polarity HOLD high (default) or HOLD low, software selectable
6-8
 previous next