Filter
Top Products
26
Pulsar EX: 51032306XT/BB MGE UPS SYSTEMS
yellow indicator lights 1a to 1d
flashing quickly :
1a overload,
1b UPS fault,
1c battery fault,
1d load on "manual bypass" (if option
available),
yellow indicator lights 1a to 1d on
continuously or flashing slowly: the lights
indicate the battery charge level (if mains
power is available) or remaining battery
backup time (if AC power is not available) in
the form of a bargraph. If you press the test
button 2 , the lights indicate the load level.
1e green indicator light flashing: UPS
operating on battery,
green indicator light off: UPS operating
on AC power,
1f green indicator light on continuously:
load supplied by UPS,
green indicator light flashing: load
supplied by the AC power via the
"automatic bypass",
green indicator light off: load not
supplied,
2 test button:
press and hold down to activate a
bargraph formed by indicator lights 1a
to 1d displaying the load level,
press and release to test the indicator
lights,
3 load "ON/OFF" button:
button pressed down: load supplied,
button released: load not supplied,
4 socket for connecting AC power cable
or connector for manual bypass
module,
5 AC power cable (not supplied with the
"INSTALL" version),
6 connector for connection modules,
7 battery switch,
8 rear ventilation grid,
9 connector for Pulsar EXB battery
extension module (option), with
protective cover,
10 "Basic" communications port
(status information),
11 "U-Talk" communications port
(RS-232/ASCII),
12 connector for the "manual bypass"
module,
13 SNMP communications port (activated
only with Pulsar EX, SNMP version),
14 name plate,
15 connector for the "automatic bypass"
module, protected by an optional cover,
16 warranty card,
17 UPS Service label,
18 EX Driver software disk,
19 Solution-Pac
TM
CD-ROM,
20 communication cable for SUB-D
connector 11 ,
21 automatic bypass module,
22 "output sockets" module,
23 load sockets to directly connect your
loads to Pulsar EX,
24 2 screws for securing connection
modules to Pulsar EX,
25 "manual bypass" module: "Hot-swap"
version,
26 cable for connecting "manual bypass"
module to Pulsar EX ("manual bypass"
status information),
27 socket for connecting the AC power
cable,
28 "manual bypass",
29 output terminal blocks,
30 input terminal blocks,
31 "manual bypass" module: "install"
version,
32 battery circuit breaker for Pulsar EXB
module (option),
33 connector for Pulsar EXB battery
extension module (option),
34 connector for an additional Pulsar EXB
battery extension module,
35 battery connection cable (supplied with
Pulsar EXB).
key to diagrams