Filter
Top Products
12
Clean
The Clean page allows you to run a cleaning cycle on the
ink cartridge.
Like the Test disc, a disc must be placed directly on the
belts below the input hopper for the utility to function.
Click the Clean button once a disc has been loaded to the
belts. If the resulting disc shows streaks similar to those
shown in the image on this page, you may need to run the
Clean utility again.
Utility
The Alignment values will move the print image on the disc
in 0.1 mm increments.
The Outer and Inner Diameters will change the size of the
area to be printed. To avoid excessive ink buildup, these
values should never be set so that the GX Auto Printer is
printing off the media.
If you have media with a printable inner hub separated from
the rest of the disc by an unprintable ring, you can set the
inner and outer hub diameters appropriately. If you are
using media with a continuous print surface, the Print on
Hub setting should not be checked.
Print Alignment CD will print out the alignment pattern.
This should only be done using a pre-printed alignment CD.
Factory Settings will restore the values to the default values. The Top and Left Side values will be
changed to 0.
Revert will discard any changes you have made since the Apply button was clicked.
Support
Clicking the Support button will open the Microboards Technology Support website in your default
internet browser. This function requires an internet connection.
Register
Clicking the Register button will open your default internet browser to the Microboards Product
Registration webpage. When registering your GX Auto Printer, please be sure you are including the
correct serial number, which will be on the back of the GX Auto Printer and on the box product label.
This function requires an internet connection.