MicroBoards Technology GX Auto Printer Label Maker User Manual


 
6
Input Rods
Output Bin
System Requirements
The Microboards GX Auto Printer has the following minimum requirements and compatibilities:
Operating System
Mac OS 10.3.9 or above.
Processors
G 4 Power PC Processor, running at 1.2 GHz or faster; -or- Intel Processor.
System Memory
Minimum 512 MB of system memory. 1GB is recommended for DVD recording operation.
Hard Drive
A separate internal 7200 RPM hard drive is recommended for storing your data. Using the same
hard drive as the operating system can cause the system to perform slowly.
USB Connection
USB 2.0 is recommended. USB 1.1 may be used but is not recommended, as using USB 1.1 may
result in more time being necessary for print images to be passed to the printer.
Assembly and Installation
Assembly Instructions
GX Auto Printer Assembly
Remove the GX Auto Printer system from the shipping box and confirm
you received all of the items.
Place the GX Auto Printer on a stable, flat surface. You will need room
both in front and to the left of the system, as discs will be accessed
from both locations.
The input bin posts are pre-installed, with the wide post to the front.
The Reject Bin is pre-installed on the left side of the GX Auto Printer.
This bin, which slides out, should be emptied when you know discs
have been rejected.
Slide the 50-disc Output Bin into the channel between the feet at the
front of the GX Auto Printer, shown below.