Filter
Top Products
61
Upgrade Firmware: You can use this “Upgrade Firmware” tool to update
the newest firmware of the print server. Click “
” button and select the
correct firmware in your PC. After selecting the firmware file, click the
“Upgrade” button to finish the firmware update process. If you want to
reset the Print Server to default factory settings, please click “Load
Default”.
Note that before you upgrade the firmware please make sure that the IP
Address settings of the MFP Server are in the same network as your
computer.
Wireless Function: You can select “Enable” or “Disable” to manually
enable or disable the wireless function. If you manually enable wireless
function, the print server’s wireless LAN will be always enabled and
Ethernet will be always disabled. If you manually disable the wireless
function, the print server’s wireless LAN will be always disabled and
Ethernet will be always enabled. You also can select “Auto” to let the print
server automatically decide to enable or disable the wireless function. The
print server only can work in ether Ethernet or wireless LAN mode. It
cannot work in both Ethernet and wireless LAN mode at the same time.
When the print server starts up, it will auto-detect if the LAN port is
connected to an active network by an Ethernet cable. If the print server is
connected to an active network by Ethernet cable when starting up, the
print server will run in Ethernet mode. If the print server is not connected
to an active network by Ethernet cable when starting up, the print server
will run in wireless LAN mode. The print server default is in “Auto” mode.
Domain Country: The wireless channels are different from country to
country. Generally, the channels are from 1 to 11 in USA and from 1 to 13
in Europe. The Domain Country setting is for you to set the available
channels according to your location.