Filter
Top Products
Reception Features
90
5
❖
❖❖
❖ Priority Table
• KK and LL indicate that the
message is split over two pages of
paper with the orientation and size
shown.
Note
❒ Paper placed in the bypass tray is
not usually selected for printing a
received message. However, you
can use this tray if you select the
bypass tray as the main paper tray
using Reception with Specified
Senders. See p.152 “Special Send-
ers to Treat Differently”.
❒ Widths that this machine can re-
ceive are A4, B4 JIS, and A3. Any
messages narrower than A4 are
sent as A4 width with the length
unchanged.
❒ The paper size used to print a re-
ceived message may be different
from the size of the sent original.
❒ If you specify a receiving tray with
the setting priority under System
Settings, the messages may be re-
ceived in a different order by set-
ting the priority table. The priority
tray may be used only when the
document received is the same size
as the priority tray.
Reference
p.88 “Page Separation and Length
Reduction”
p.89 “Page Reduction”
p.87 “Image Rotation”
Just Size Printing
If you turn this function on and no pa-
per tray is stocked with paper of a
suitable size to print a received docu-
ment, a message will appear on the
display prompting you to load paper
of the required size. When you have
loaded new paper, you can then print
the message.
Two messages can appear:
• Paper Cassette
Page reduction Disabled
Reduction in Sub-
scan Direction
Enabled
Page Separation
Threshold
20 mm (0.79")
Width or Length Pri-
ority
Width