Milan Technology MIL-SM801P Switch User Manual


 
55
2. Priority Queue Service settings:
First Come First Service: The sequence of packets sent is dependent on
the order of arrival. The first packets in the queue are transmitted before
any other packets.
All High before Low: The high priority packets are sent before the low
priority packets.
Weighted Round Robin: This option enables the user to choose a ratio of
the number of high priority packets sent before one low priority packet is
sent. For example, 2:1 (2 High : 1 Low) will have the switch send 2 high
priority packets before sending 1 low priority packet.
Enable Delay Bound: Limits the low priority packets queuing time in the
switch. Default Max Delay Time is 255ms. If the low priority packet exceeds
the Max Delay Time, it will be sent. The valid range is 1~255 ms.
NOTE: Make sure the “Max bridge transit delay bound control” is enabled
before enabling Delay Bound. The Enable Delay Bound only works under
“Max bridge transit delay bound control is enabled”.
QoS Policy: High Priority Levels: 0~7 priority level can map to a high or
low queue. When the VLAN Tag number of a frame is mapped as a high
priority level, the frame always has a high priority. In this example, the QoS
policy applies to the switch, not for a single port.