Filter
Top Products
6.2 UNIX Printing
6-23
TCP/IP Configuration
Chapter 6
8. Confirm the preceding connection as your system default.
Type:
Y
9. Enter another printer name or quit setup. Type: Q
10. “Do you want to start the remote daemon now?” Type: Y
11. Using a line editor of your choice, edit the /etc/printcap file by
changing the :rp= entry to
PORT1. For example,
printer1:\
:lp=:\
(used to specify the device name for a local
printer; this field must be empty)
:rm=printfast:\
(NIC hostname as in /etc/hosts)
:rp=PORT1:\
:sd=/usr/spool/lpd/printer1:
(name of the spool directory on the client)
6.2.2.8 Setting Up System V Rel.4 and Solaris 2.X to
Use lpd
If your system recognizes the LPSYSTEM command, you can use
lpd. Another option is the admintool if your system supports it.
LPSYSTEM Installation
Use the following procedures to install LPSYSTEM:
Note
1. At the prompt, type:
#lpsystem -t bsd <NIC IP address>
2. Enter NIC host name in /etc/hosts file. Your system may want
its IP address instead of the remote host name.
• The following must be executed from the Bourne Shell. Type:
#sh
to enter the Bourne Shell program.
PageWorks.book Page 23 Tuesday, August 4, 1998 11:21 AM