Filter
Top Products
3.1 Discovery Program – Management Access Program (MAP)
3-5
Utilizing Windows Programs
Chapter 3
1. Insert the CD-ROM into your workstation’s CD-ROM drive. The
opening screen appears automatically.
2. Click the
CD-ROM Contents button to display the Introduction
screen.
3. Click
Installation/Configuration Programs located at the bottom
of the
Introduction screen.
4. Select the program you want to install and follow the instructions
displayed on the screen.
You can use the following procedure to manually install the IP
Discovery Program.
1. Insert the CD-ROM into your workstation’s CD-ROM drive.
2. Run the program. (In this example, we assume that drive D: is
your workstation’s CD-ROM drive.)
D:\Ip-Disc\Setup.exe
3. Follow the instructions that appear on the screen.
The default installation directory is C:\Program Files\IP-disc. You can
change to a different directory if you want.
Setting Up IP Discovery Program
1. Click
Start, point to Programs, and then point to IP Discovery.
2. Click
IP-Discovery Setup.
3. Type in a maximum hop value and then click
OK to set it. The ini-
tial default maximum hop value is 2. See the note under 3.1.2 Con-
figuring the MAP for an explanation about maximum hops.
Using IP Discovery Program
Use the following procedure to start up IP Discovery and search for all
compatible NICs that are available on a network.
1. Click
Start, point to Programs, and then point to IP Discovery.
2. Click
IP-Discovery.
A list of NICs found by the IP Discovery search appears on the Web
Browser installed on the workstation.
3. To configure or reconfigure a particular NIC, click its URL (http://
followed by an IP address) in the Web Browser list.
3.1 Discovery Program – Management Access Program (MAP) –
PageWorks.book Page 5 Tuesday, August 4, 1998 11:21 AM