Filter
Top Products
- 17 -
The following is a description of the fields contained on this page:
• Event Displays the name of the event that is being configured.
• Paging Enabled Select the checkbox to enable paging for this event. This option allows you to retain
your settings whether the option is enabled or disabled.
• Delay The amount of time in seconds, after the event occurs, before paging is performed.
If the event is removed before the delay time is reached, the paging will be cancelled.
• Port The dedicated serial communications port used when paging is performed. A
modem must also be available and properly configured for this port.
• Alarm-Add The numeric message sent, as the page, when an event is added.
• Alarm-Remove The numeric message sent, as the page, when an event is removed.
• Pager Number Up to five separate pages may be configured. Each field must contain only one
paging phone number followed by any codes required by the paging service to
complete the page.
The phone number must contain any access numbers required for the phone system
to gain access to an outside line, such as dialing 8 or 9. Each comma (,) represents
three (3) seconds dialing pause time. This allows the modem to pause before
sending a sequence of numbers to the paging system. There may be times, when a
pause is required, before the paging system is ready to receive the next numeric
command.
It may be necessary to test the pause time until it is determined to be functioning
properly. This may require an event to be manually triggered. See the UPS Control
Options section to trigger an event.
Valid characters are limited to 0 through 9, comma (,) and the pound sign (#).
An example pager number follows: 1,8007597243,,,,,123456#,,,
The numeric 1 would be dialed.