Filter
Top Products
FX2N-32DP-IF Profibus-DP Interface Units Appendix B
B-6
B-3 Adjusting Offset and Gain
The user parameter settings are as shown in FX
2N
-4AD example. For FX
2N
-4DA, the settings
must correspond to their respective BFM locations. For definitions of the BFM’s, refer to each
modules user’s manual.
Note:
To adjust offset/gain, follow process in Figure B-1.
Going to next step, must be delay times as follows.
Figure B-1:Process for Adjusting Offset/Gain
Table B-6:Delay Times
Items Delay Times
FX
2N
-4AD 300 ms
FX
2N
-4DA 3 s
First step (Table B-7): Ready for adjusting
Second step (Table B-8, B-9): Offset and gain data write to FX
2N
-4AD or FX
2N
-4DA
Last step (Table B-10): Protected these setting data
If adjusting other channel or setting
again, return to second step.
Going to next step, must be delay time as show Table B-1.
Going to next step, must be delay time as show Table B-1.
Going to next step, must be delay time as show Table B-1.