Mitsubishi Electronics HC7800D Projector User Manual


  Open as PDF
of 61
 
EN-36
Menu operation (continued)
INFORMATION menu
INFORMATION
opt.
LAMP TIME(LOW)
INPUT
RESOLUTION
VERTICAL
FREQUENCY
HORIZONTAL
FREQUENCY
SYNC. TYPE 5wire
60.02 KHz
75.04 Hz
1024X768
COMPUTER
0 H
RG
HV
B
ITEM DESCRIPTION
LAMP TIME(LOW) This item shows a lamp operating time (hour) calculated based on that LAMP MODE
is LOW.
• WhentheLAMPMODEisSTANDARD,thisitemshowsalongerlampoperating
time than the actual time. (See page 48 for the interval of lamp replacement. )
• Whenthelampoperatingtimeis0to10hours,“0H”isdisplayed.Thelamp
operating time exceeding 10 hours is indicated by the actual hours.
• Whenthelampoperatingtimereaches3750hours,thebarturnstoyellow.When
it reaches 4750 hours, the bar turns to red.
INPUT Indicates the name of the terminal to which the currently projected video signal is
being input.
RESOLUTION Indicates the resolution of the currently projected video signal.
VERTICAL FREQUENCY Indicates the vertical frequency of the currently projected video signal.
HORIZONTAL FREQUENCY Indicates the horizontal frequency of the currently projected video signal.
SYNC. TYPE Indicates the type of the sync signal for the currently projected video signal.
AV memory
In addition to the default picture modes (CINEMA, VIDEO, and 3D), you can use up to 3 patterns of customized
picture quality settings that are stored for each input source.
• Fordetailsaboutthepicturequalitysettingsyoucanstore,seepage30.
To store the settings:
1. Select PICTURE MODE in the IMAGE menu.
2. Press the t or u button to select AV MEMORY (1, 2 or 3) to store the settings.
3. Make the picture quality settings in the IMAGE menu as desired.
4. Select PICTURE MODE again.
5. Press the ENTER button.
• Adialogboxconrmingyouwanttostorethesettingsappears.
6. Press the ENTER button.
• Thesettingsyoumadearestored.
To enable the stored image quality settings:
1. Press the AV MEMORY button to call up the stored setting.
• Whenyoucallupthestoredsettingsandmakechangestothem,thechangesremaineffective.However,they
aren’t saved to the AV MEMORY unless you perform the procedure for saving them to the AV MEMORY.
• Whentheinputsourceischanged,theAVmemorysettingselectedjustbeforeisautomaticallyselected.
• WhenRESETALLintheFEATUREmenuisselected,allthesettingsoftheAVmemoryarecleared.
Adjusting projected images
 previous next