Filter
Top Products
EN – 10
Basic connections
This projector can be connected with various devices such as a VCR, video camera, videodisc player, and personal
computer that have analog RGB output connectors.
Important:
• Make sure that the connected device is turned off before starting connection.
• Plug in the projector and the connected devices firmly, and unplug them by holding and pulling out their
power plugs, not by pulling the power cords.
• When the projector and the connected devices are located too close to each other, the projected image may be
affected by their interference.
• See the owner’s guide of each device for details about their connections.
Projector + AV device
Important:
• Connect the video and audio plugs of the AV cable to the proper terminals matching their colors respectively.
• The S-video signal takes priority over the video signal. When you input both the S-video signal and the
normal video signal at the same time, the normal video signal is ignored.
• When the connected AV device uses a BNC connector for its video output, connect it to the VIDEO IN2 (BNC)
terminal. When both the VIDEO IN2 (BNC) terminal and the VIDEO IN2 (RCA) terminal are engaged at the
same time, the image supplied to the VIDEO IN2 (RCA) terminal takes priority.
Connect either
one of these.
To S-video input
To S-video output
To video input
To audio input
To video output
To audio output
VCR, etc.
B G R
B/PB
G/Y
R/P
R
C
B
(P
B
)
Y
C
R
(P
R
)
DVD player or HDTV decoder
BNC - RCA connector
(option)
BNC-BNC cable (option)
to AUDIO OUT
AUDIO cable
To COMPUTER
AUDIO IN
Projector + DVD player or HDTV decoder
Some DVD players have an output connector for 3-line fitting (Y, CB, CR). When connecting such a DVD player
with this projector, use the COMPUTER/COMPONENT VIDEO 2 IN terminal.
• The terminals’ names Y, PB, and PR are examples of a case where a HDTV decoder is connected.
• The terminals’ names are different depending on the connected devices.
• Use BNC-BNC cables for connection.
• The image may not be projected correctly with some DVD players.
• When connecting a HDTV decoder having RGB output terminals, set the COMPUTER INPUT to RGB in the
SIGNAL menu.