Filter
Top Products
UC-7110 Series User’s Manual Getting Started
2-3
Telnet
If you know at least one of the
two IP addresses and netmasks,
then you can use Telnet to
connect to UC-7110’s console.
Default IP Address Default Netmask
LAN 1
192.168.3.127 255.255.255.0
LAN 2
192.168.4.127 255.255.255.0
Telnet can be used locally by using a cross-over Ethernet cable to connect your computer to
UC-7110, or over a LAN or the Internet. The default IP addresses and netmasks are shown above.
To login, type the Login name and password as requested. The defaults are:
Login: root
Password: root
Once you reach the “Sash command shell” you can proceed to configure UC-7110’s network
settings, as described in the next section.
ATTENTION
y Serial Console Reminder: Remember to choose VT100 as the terminal type. Use the
CBL-RJ45F9-150 cable that comes with UC-7110 to connect to the serial console port. If
you do not get connected on the first try, unplug and then re-plug UC-7110’s power cord.
y Telnet Reminder: When connecting to UC-7110 over a LAN, you must configure your
PC’s Ethernet card to be on the same subnet as the UC-7110 you wish to contact.