2 Installation
The installation of the IPDS DIMM is described in detail below.
Requirements: Minimum 8MB RAM installed in the printer.
Note: Before you start installing the IPDS DIMM, make sure that the printer is
powered off and that the power cord has been disconnected.
CAUTION
Static electricity can damage your IPDS Dual Inline Memory Module (DIMM).
When handling the IPDS DIMM, you should either wear an antistatic wrist strap,
or frequently touch the metal surface of the printer.
2.1.1 Actual installation
1. Open the interface cable door on the right side of the printer by pressing
on the release tabs. Disconnect all interface cables.
2. Facing the printer front, lift up the top cover.
3. Press the release button on the right side below the top cover. Slide the
right side panel forward until the alignment arrows line up.
4. Take the cover off, pulling it away from the printer. You will now have
access to the available DIMM slots.
5. Remove the IPDS DIMM from the antistatic bag. Hold by the edges,
component side facing towards the back of the printer. Make certain that
the locks on each side of the slot are open, and that the notches on the
IPDS DIMM are aligned with the DIMM slot. For best results, use the DIMM
slots in 1-2-3 order.
6. Press the DIMM straight into the slot (press firmly) Make certain that the
locks above and below the DIMM snap inward into place (to remove a
DIMM, the locks must be released).
Repeat steps 5 and 6 for each DIMM that is being installed
7. To replace the side panel, line up the alignment arrows and slide the panel
backwards until the release button latches into place. Close the top cover.
8. Reinstall the interface cable(s) and power cord. Turn on the printer.
4